Automatic feeding mixer will encounter some faults when working. Don't panic when faults occur again. Correct handling is the best way. Now for you to introduce the automatic feeding mixer cylinder rupture reason is what!

導致攪拌車汽缸破裂的原因有很多，要預防氣缸破裂，應該做到:發動機溫度過高時，必須等發動機溫度降低后，再加水發動；不得先啟動發動機，后加冷卻水，以免使氣缸崩裂'

There are many reasons leading to the cylinder rupture of the automatic feeding mixer. To prevent the cylinder rupture, we should do the following: when the engine temperature is too high, we must wait for the engine temperature to decrease, and then add water to start; it is not allowed to start the engine first, and then add cooling water, so as not to cause the cylinder rupture

在嚴寒條件下，需放盡冷卻水，啟動車時加熱水啟動；冬季停車若時間較長，又不能放水時，可間歇發動車輛，保持發動機有一些溫度而不于結冰，不得用噴燈或明火直接烤車，同時使用的冷卻水要潔凈。

In severe cold conditions, it is necessary to drain cooling water and start the car with heated water. If the car stops for a long time in winter and water can not be drained, it can start the car intermittently to keep the engine at some temperature without freezing. It is not allowed to bake the car directly with blowtorch or open fire, and the cold water used at the same time should be clean.

自動上料攪拌車如果氣缸套出現破損，發動機在進氣行程時會吸入冷卻液，而在壓縮行程時高壓氣體會從破損處進入冷卻水道。無論出現哪一種情況，都將妨礙可燃混合氣的形成和燃燒，甚使發動機無法正常工作，將嚴重影響發動機的使用壽命。

If the cylinder liner of automatic feeding mixer is damaged, the engine will inhale coolant during the intake stroke, and the high-pressure gas will enter the cooling channel from the damaged part during the compression stroke. No matter what happens, it will hinder the formation and combustion of combustible mixture, and even make the engine unable to work normally, which will seriously affect the service life of the engine.