正確使用自動上料攪拌車有利于施工的順利進行，并且可以提高工程工作效率，如果沒有正確使用會(huì )損害設備的機械部件，減少它的使用壽命。今天就讓小編為大家簡單介紹一下自動上料攪拌車散熱器的正確使用方式：

The correct use of the automatic feeding mixer is conducive to the smooth construction, and can improve the work efficiency of the project. If it is not used correctly, it will damage the mechanical parts of the equipment and reduce its service life. Today, let's brief you on the correct way to use the radiator of the automatic feeding mixer:

1、備用的散熱器有效環境應保持通風、干燥。

1. The effective environment of the standby radiator shall be ventilated and dry.

2、建議使用軟硬水需軟化處理后使用，避免造成散熱器內部堵塞及水垢的產生。

2. It is recommended that soft and hard water should be softened before use to avoid blockage and scale inside the radiator.

3、在冬季為防止結冰造成芯子破裂現象，如攪拌車長期停車或間接停車時，應將水箱蓋和放水開關，將水全部放出。

3. In winter, in order to prevent core fracture caused by ice formation, if the mixer truck is stopped for a long time or indirectly, the water tank cover and drain switch shall be used to drain all water.

4、水位計應每3個月清洗一次或視實際情況，各部件拆下用溫水加無腐蝕性洗滌劑清洗。

4. The water level gauge shall be cleaned every 3 months or as the case may be, each component shall be removed and cleaned with warm water and non corrosive detergent.

5、散熱器內完全放水再注水時，要先將發動機缸體的放水開關扭開，有水流出時，再關上，從而避免產生水泡。

5. When the radiator is completely drained and refilled, turn on the water drain switch of the engine block first, and then turn it off when there is water flowing out, so as to avoid water bubbles.

6、在日常使用中應隨時檢查水位，要停機降溫后加水。加水時，將水箱蓋慢慢打開，作業人員身體應盡量遠離加水口，以防高壓蒸汽油加水口噴出造成燙傷。

6. Check the water level at any time during daily use, and add water after shutdown for cooling. When adding water, slowly open the water tank cover, and keep the operators away from the water inlet as far as possible to prevent scalding caused by the spray of high-pressure gasoline.

7、散熱器不應與任何酸、堿或其它腐蝕性性質接觸。

7. The radiator shall not contact with any acid, alkali or other corrosive properties.

8、在使用防凍液，為了避免散熱器的腐蝕，請務必使用正規廠家生產且符合標準的長效防銹防凍液。

8. When using antifreeze, in order to avoid the corrosion of the radiator, please be sure to use a long-term anti rust antifreeze produced by a regular manufacturer and meeting the national standard.

9、視實際情況用戶應在1～3個月間對散熱器進行完全清洗一次芯體。清洗時，用清水沿反進風向側沖洗。

9. Depending on the actual situation, the user shall completely clean the core of the radiator once within 1-3 months. When cleaning, use clean water to wash along the reverse wind direction.

10、在安裝散熱器過程中，請不要損壞散熱帶（片）和碰傷散熱器，以保證散熱能力和密封。

10. During the installation of the radiator, please do not damage the radiator ribbon (fin) or damage the radiator to ensure the heat dissipation capacity and sealing.

使用時的重中之中是要嚴格按照使用說明進行操作，一般在夏季如果自動上料攪拌車溫度過高應該立刻停下來，等溫度降下來后再繼續使用。關注我們http://kitchinit.com，了解更多相關事項！

The most important thing is to operate in strict accordance with the instructions. Generally, if the temperature of the automatic feeding mixer is too high in summer, it should stop immediately and continue to use after the temperature drops. Follow us http://kitchinit.com , learn more about it!