攪拌一體車在使用過程中也會因為缺少一些養護或者什么原因，而導致相關問題的出現，所以在此小編給您幾個參考事項，您可以看看。

During the use of the mixer, related problems may occur due to lack of maintenance or some other reasons, so here are some reference items for you to see.

注意事項：

matters needing attention:

1、各傳動齒輪、減速箱、鏈條等是否按規定加足潤滑油；

1. Whether all transmission gears, reduction boxes, chains, etc. are fully lubricated as required;

2、攪拌筒運轉平穩，襯板、葉片、沒有松動現象

2. The mixing drum operates stably, and the lining plates and blades are free from looseness

3、傳動部分聲音是否正常，減速箱、軸承是否有發熱或漏油現象；

3. Whether the sound of the transmission part is normal, and whether the reduction gearbox and bearing have heat or oil leakage;

4、傳送帶松緊度是否合適，傳動鏈條中部下沉不得大于20mm；

4. Whether the tightness of the conveyor belt is appropriate, and the middle of the drive chain should not sink more than 20mm;

5、鋼絲繩有無較大磨損，連接是否牢固；

5. Whether the steel wire rope is severely worn and firmly connected;

6、制動器和離合器性能是否良好，制動片是否磨損嚴重，需不需要更換。

6. Whether the performance of the brake and clutch is good, and whether the brake pads are seriously worn. It is unnecessary to replace them.

日常維護工作：

Daily maintenance:

按照規定在每一次主機啟動時給攪拌機軸端密封定時加油，以保證油封結構長期正常運轉；

Oil the shaft end seal of the mixer regularly at each start of the main engine as required to ensure the normal operation of the oil seal structure for a long time;

檢查其他的加油點如各轉動、轉動輪和軌道等是否需要加油。

Check whether other refueling points such as rotating wheels, rotating wheels and rails need refueling.

檢查易損部件，如襯板、葉片、攪拌臂等，及時調整或更換。

Check vulnerable parts, such as lining plate, blade, mixing arm, etc., and adjust or replace them in time.

保養機體的清潔，機體上的污物和障礙物。

Maintain the cleanness of the body and remove dirt and obstacles on the body.

檢查各潤滑處的油料及電路和控制設備，并按要求加注潤滑油。

Check the oil, circuit and control equipment at each lubrication point, and add lubricating oil as required.

攪拌一體車運轉過程中，應隨時檢聽電動機，減速器，傳動齒輪的噪聲是否正常，溫升是否過高。

During the operation of the mixer truck, check whether the noise of the motor, reducer and transmission gear is normal and whether the temperature rise is too high.

每班工作前，在攪拌筒內加水空轉1--到2min，同時檢查離合器和制動裝置工作的可靠性。每班工作結束后，應認真清洗攪拌一體車。關注我們http://kitchinit.com，了解更多！

Before each shift, add water into the mixing drum and idle for 1 - to 2min, and check the reliability of the clutch and brake device. After the work of each shift, the mixer truck shall be carefully cleaned. Follow us http://kitchinit.com , learn more!