In the implementation of all-in-one mixer testing steps, inform everyone of unknown problems and knowledge. But we are still relatively unfamiliar with our industry. Today we come to understand:

1.電池維護檢查：檢查電池是否牢固固定。

1. Battery maintenance inspection: check whether the battery is firmly fixed.

2.輪胎檢查：有必要每月在室溫下檢查輪胎壓力。

2. Tire inspection: it is necessary to check the tire pressure at room temperature every month.

3.檢查離合器主泵的水位。離合器液位正常。如果低于標準線，則可能會損壞主泵或泵筒。

3. Check the water level of clutch main pump. The clutch fluid level is normal. If it is below the standard line, the main pump or pump barrel may be damaged.

4.檢查制動液的液位。制動液在高位和低位之間也是正常的。

4. Check the brake fluid level. The brake fluid is also normal between high and low.

5.檢查發動機冷卻液液位：發動機熱時請勿打開散熱器蓋。如果打開，冷卻劑和熱蒸汽可能會散開并引起灼傷。發動機冷卻時，請確保冷卻液液位在滿和低之間。否則，您需要添加蒸餾水或純凈水或冷凍溶液。加水后液體的高度不應超過滿水位。如果您發現冷卻液在短時間內急劇下降，則自動攪拌器檢查步驟應檢查冷卻系統是否泄漏或前往維護站進行檢查。

5. Check the engine coolant level: do not open the radiator cap when the engine is hot. If turned on, the coolant and hot steam may disperse and cause burns. When the engine is cooling, make sure that the coolant level is between full and low. Otherwise, you need to add distilled or purified water or frozen solution. After adding water, the liquid height should not exceed the full water level. If you find that the coolant drops sharply in a short time, the automatic mixer inspection procedure should check whether the cooling system leaks or go to the maintenance station for inspection.

攪拌一體車的檢驗程序的污泥對自給式攪拌機的影響，你了解了嗎？

Do you understand the influence of sludge in the inspection procedure of mixer on self-contained mixer?