On the surface, it's easy to clean the center console of the automatic feeding mixer with a piece of cloth. In fact, if you pay a little attention to it, you will find that there are many "gullies" in the dashboard that need special tools.

這時候，可以找一些不同厚度的木片或尺子，將其一端修成三角等較尖的樣式，然后包在干凈的抹布里進行清理。比如說自動上料攪拌車空調送風口的百葉部分，用普通抹布很難清理到位，但如果用抹布包上一把尺子，就很容易完成了。

At this time, you can find some pieces of wood or ruler with different thickness, trim one end into a triangle and other sharp style, and then pack it in a clean rag for cleaning. For example, the louver part of the air-conditioning air supply outlet of the automatic feeding mixer is difficult to clean with ordinary rags, but if a ruler is wrapped with rags, it is easy to complete.

1、 常被遺忘的點火線

1. Often forgotten ignition wire

火花塞大家都很熟悉了，但點火線卻經常被大家遺忘。當自動上料攪拌車出現不容易著火、油耗增加、動力差等癥狀時，建議檢查一下點火線。點火線兩端分別連接分電器和火花塞，是傳遞給自動上料攪拌罐發動機電火花的路徑。

We are all familiar with the spark plug, but the ignition wire is often forgotten. When the automatic feeding mixer is not easy to fire, fuel consumption increases, poor power and other symptoms, it is recommended to check the ignition line. Both ends of the ignition wire are respectively connected with the distributor and the spark plug, which is the only way to transmit the spark to the automatic feeding mixing tank engine.

由于其使用頻率高，工作環境也比較惡劣，會很容易出現老化、破損等現象，造成點火能量不足。建議，自動上料攪拌罐每兩萬更換點火線。

Because of its high frequency of use and bad working environment, it is easy to appear aging, damage and other phenomena, resulting in insufficient ignition energy. Experts suggest that the ignition line of automatic feeding mixing tank should be replaced every 20000 km.

2、剎車盤也需要關注

2. Brake discs also need attention

目前越來越多的自動上料攪拌車都逐漸從前盤后鼓的制動配置向前盤后盤的配置過渡，采用盤式剎車的好處在于散熱更好，清理和更換更加方便。多數司機認為，剎車片比剎車盤更容易磨損，事實上盤與片的作用力都是相互的，接觸摩擦都會有磨損。

At present, more and more automatic feeding mixers are gradually transiting from the brake configuration of front disc and rear drum to the configuration of front disc and rear disc. The advantages of using disc brake are better heat dissipation and more convenient cleaning and replacement. Most drivers think that the brake pads are easier to wear than the brake discs. In fact, the forces between the discs are mutual, and there will be wear in contact friction.

另外自動上料攪拌車剎車盤表面比剎車片光滑，容易受剎車片粗糙表面的影響。所以在檢查更換剎車片的同時，也要注意自動上料攪拌車剎車盤表面的狀況，如果出現比較清晰的劃痕，建議更換新的自動上料攪拌車剎車盤，以免后患。

In addition, the surface of the brake disc of the automatic feeding mixer is smoother than that of the brake pad, which is easily affected by the rough surface of the brake pad. Therefore, when checking and replacing the brake pads, it is also necessary to pay attention to the surface condition of the brake disc of the automatic feeding mixer. If there are relatively clear scratches, it is recommended to replace the brake disc of the automatic feeding mixer to avoid future trouble.