In summer, in order to prevent unnecessary accidents, the power supply of concrete mixer should be taken seriously. Therefore, it is imperative to strengthen the power management of automatic feeding mixer. So, how to strengthen the power management?

，該行業有專注化，尋找專注電工安裝。安裝自動上料攪拌車時，應豎立電線，安裝和維護的電氣設備應由有資格進行檢查的電工按照電源設計規范，程序和合理安裝進行。使用電加熱器和各種電氣設備時，須由專人負責使用和管理，離開時須切斷電源。

First of all, the industry has focus, looking to focus on electrical installation. When the automatic feeding mixer truck is installed, the electric wires shall be erected, and the electrical equipment shall be installed and maintained by qualified electricians according to the power supply design specifications, procedures and reasonable installation. When using the electric heater and various electrical equipment, it must be used and managed by a specially assigned person, and the power must be cut off when leaving.

加強安 全知識的培訓和管理。臨時電力線的安裝應根據固定電源的規格設定。電源線應位于隱蔽裝置內，電源線應豎立在安 全的地方，以避免接觸，擠壓或懸掛。禁止使用電爐和各種電熱器具進行保溫和烹飪。

Strengthen the training and management of safety knowledge. The installation of temporary power line should be set according to the specification of fixed power supply. The power cord shall be located in the concealed device, and the power cord shall be erected in a safe place to avoid contact, extrusion or suspension. It is forbidden to use electric furnace and various electric heating appliances for heat preservation and cooking.

做好定期檢查。務必檢查自動上料攪拌車的電線和電氣設備，發現可能造成的任何短路，火災，高溫或絕緣不好，須立即進行維修或更換。禁止使用不合格的安 全裝置，不允許使用銅線，鐵線或鋁線代替保險絲。電氣設備的電源線不得超過安 全負載。

Do a good job of regular inspection. Be sure to check the wires and electrical equipment of the automatic feeding mixer. If any short circuit, fire, high temperature or poor insulation is found, repair or replace them immediately. It is forbidden to use unqualified safety devices, and it is not allowed to use copper wire, iron wire or aluminum wire instead of fuse. The power line of electrical equipment shall not exceed the safe load.