1. Battery maintenance check: check whether the battery is fixed firmly.

2、輪胎的查看：每月應在常溫下查看一下輪胎氣壓。

2. Tire inspection: check the tire pressure at normal temperature every month.

3、離合器總泵液面的查看：離合器液面介于高、低液面間則表明正常，假如低于標準線，則或許是總泵或分泵皮碗損壞。

3. Check the liquid level of clutch master cylinder: if the liquid level of clutch is between high and low, it indicates that it is normal. If it is lower than the standard line, it may be that the leather bowl of master cylinder or slave cylinder is damaged.

4、制動液面的查看：制動也在高、低位之間則表明正常。

4. Check the brake fluid level: if the brake is also between high and low, it indicates normal.

5、發起機冷卻液液面查看：發起機在熱機狀態時，千萬不要打開散熱器蓋，不然或許會被濺起的冷卻液或高溫蒸氣燙傷。等發起機冷卻后，查看冷卻液的液面應處于滿位和低位之間，不然應加蒸餾水或純凈水或冷凍液，加水后的液面高度不能超過滿位。如發現短時間內冷卻液減少的很快攪拌，自動上料攪拌機保養小貼士應查看冷卻系統是否有泄漏或到維修站去查看。

5. Check the coolant level of the engine: never open the radiator cap when the engine is hot, or it may be scalded by the splashed coolant or high temperature steam. After the initiator cools down, check that the liquid level of the coolant should be between the full level and the low level, otherwise add distilled water or purified water or freezing liquid, and the liquid level after adding water should not exceed the full level. If it is found that the coolant is reduced and stirred quickly in a short period of time, the maintenance tips of the automatic feeding mixer shall check whether the cooling system leaks or go to the maintenance station to check.

混凝土運送攪拌車常常應用在建筑行業，在對它進行使用的時分避免不了油泥，下面就為我們介紹一下油泥對它的影響。

The concrete mixer is often used in the construction industry. When it is used, the sludge cannot be avoided. Next, we will introduce the impact of the sludge on it.

1、發起機尾氣排放變差，同時也會縮短火花塞、氧傳感器、三元催化器的使用壽命。

1. The poor exhaust emission of the engine will shorten the service life of spark plug, oxygen sensor and three-way catalyst.

2、發起機動力下降，加速不暢，油耗添加。

2. Initiate the reduction of maneuverability, poor acceleration and fuel consumption.

3、混凝土運送攪拌車?yán)鋯?dòng)困難，冷車怠速達不到規則的轉速，嚴峻時冷車怠速會熄火，熱車后怠速低。

3. It is difficult for the mixer truck to start cold, and the idle speed of the cold truck can not reach the regular speed. In severe cases, the idle speed of the cold truck will turn off, and the idle speed of the hot truck will be low.

4、積碳也會造成發起機的活塞環的卡滯，影響活塞環的密封性能，攪拌車造成機油消耗量添加，導致發起機燒機油，縮短了發起機的使用壽命。

4. The carbon deposit will also cause the piston ring of the starter to be stuck, which will affect the sealing performance of the piston ring. The mixer will add oil consumption, cause the starter to burn oil, and shorten the service life of the starter.