油泥是長期用礦物油留下的，特別是加了機油添加劑的攪拌一體車發動機，更容易積油泥。那么攪拌車油泥影響體現在哪方面？要這么呢？下面由廠家為大家分析攪拌一體車如何清理油泥。

Oil sludge is left by mineral oil for a long time, especially for the engine of the agitator car with engine oil additives, which is easier to deposit oil sludge. What are the impacts of sludge from mixer trucks? How about this? Next, the manufacturer will analyze how to clean the sludge of the mixer truck.

攪拌車油泥影響體現：

The influence of sludge on the mixer truck is reflected in:

1.冷啟動困難，冷車怠速達不到規定的轉速，嚴重時冷車怠速會熄火，熱車后怠速低。

1. It is difficult to start cold. The idle speed of the cold car cannot reach the specified speed. In severe cases, the cold car will stall at idle speed, and the idle speed will be low after the hot car.

2.發動機動力下降，加速不暢，油耗增加。

2. Engine power drops, acceleration is not smooth, and fuel consumption increases.

3.發動機尾氣排放變差，同時也會縮短火花塞、氧傳感器、三元催化器的使用壽命。

3. Engine exhaust emissions become worse, which will also shorten the service life of spark plugs, oxygen sensors and three-way catalytic converters.

4.積碳也會造成發動機的活塞環的卡滯，影響活塞環的密封性能，攪拌車造成機油消耗量增加，導致發動機燒機油，縮短了發動機的使用壽命。

4. Carbon deposition will also cause the piston ring of the engine to be stuck, which will affect the sealing performance of the piston ring. The mixer truck will cause increased oil consumption, which will lead to engine oil burning and shorten the service life of the engine.

要這么：

To solve this problem:

如果油泥實在太厚，而你又不想拆發動機的話，可以把氣門室蓋和機油底殼拆下來，用柴油浸泡，再用汽油刷洗既可，特別是機油泵，一定要拆下來仔細清洗，但拆一次蓋子和油底殼就要更換墊子。

If the sludge is too thick, and you don't want to remove the engine, you can remove the valve cover and oil pan, soak them in diesel oil, and then brush them with gasoline. Especially the oil pump, you must remove it and clean it carefully, but replace the gasket when you remove the cover and oil pan.

一般不拆發動機有兩種簡單清洗方法，一種添是加在機油里的清洗油，還有一種是用機器接在發動機上，用一種清洗劑循環沖洗。攪拌車發動機里的油泥想清洗，須要把發動機解體，用超聲波機才清洗的干凈。

Generally, there are two simple cleaning methods without disassembling the engine. One is to add cleaning oil to the engine oil, and the other is to connect the machine to the engine and use a cleaning agent for circulating flushing. If you want to clean the sludge in the engine of the mixer, you need to disassemble the engine and use an ultrasonic machine to clean it.

先用一塊破布大致上清理一下，然后稍微放一點汽油出來用毛刷惉上把剩下的不好清理的往下刷。刷完以后用換下的機油或者機油瓶里剩余的那點底子惉毛刷上邊再給上一層油就行了。一般也不會專門去清理。

First, roughly clean it with a piece of rag, then put a little gasoline out and use a brush to brush down the rest that is not easy to clean. After brushing, use the replaced engine oil or the remaining base in the engine oil bottle to make up the brush and apply another layer of oil. I don't usually go to clean it up.

拆下來先用洗潔精加水洗頭遍，再用柴油洗再上機油，然后用布把多余的機油抹干凈，上到車子上就可以了。平時用淘汰的兒童牙刷沾點機油刷前后齒的接觸部位，盡量少而均勻，這樣才少沾灰塵。

After removal, first wash your head with detergent and water, then wash it with diesel oil, and then add engine oil. Then wipe the excess engine oil with a cloth, and then put it on the car. At ordinary times, use the eliminated children's toothbrush to brush the contact parts of the front and rear teeth with oil as little as possible, so as to reduce the dust.

拆下鏈條，把鏈條放入大的可樂瓶中，倒入適量清洗劑，蓋上蓋子，搖晃數次，取出裝上。

Remove the chain, put the chain into a large Coke bottle, pour in a proper amount of cleaning agent, cover it, shake it several times, take it out and install it.

攪拌車油泥影響體現在哪方面？以上就是問題的相關解答以及應對方法了，您可以當參考內容看看，更多的注意事項就來我們網站http://kitchinit.com咨詢吧！

What are the impacts of sludge from mixer trucks? The above is the answer to the question and the solution. You can refer to it as a reference, and come to our website for more precautions http://kitchinit.com Consult!