RM新时代入口

歡迎來到中科聚峰機械有限公司!

24小時服務熱線:

400-879-1999

點擊撥打服務熱線:400-879-1999
當前位置:首頁>新聞中心>公司動態修復自動上料小型攪拌車驅動系統有哪些方法?

修復自動上料小型攪拌車驅動系統有哪些方法?

來源:http://kitchinit.com/ 日期:2020-09-02 發布人:admin
概述:自動上料小型攪拌車的大多數混合操作是機械混合,主要使用中低壓立式鋼制容器作為混合設備來了解問題
修復自動上料小型攪拌車驅動系統有哪些方法?
What are the methods to repair the drive system of automatic feeding small mixer?
自動上料小型攪拌車的大多數混合操作是機械混合,主要使用中低壓立式鋼制容器作為混合設備來了解問題:
Most of the mixing operation of the automatic feeding small mixer is mechanical mixing. The medium and low pressure vertical steel containers are mainly used as mixing equipment to understand the problems
壓緊駕駛員后,卸下駕駛員軟管并收回兩輛車。關閉自動上料小型混凝土攪拌車,拆下其液壓馬達的高壓燃油管,在支撐輥和滾道之間放置一個木楔,然后將發生故障的相應接頭放在卡車上,并使用緊密驅動的軟墊其位置。相應的關節控制攪拌筒的旋轉。
After compressing the driver, remove the driver hose and retract both vehicles. Close the automatic feeding small concrete mixer, remove the high-pressure fuel pipe of its hydraulic motor, place a wooden wedge between the support roller and the raceway, and then place the corresponding joint with failure on the truck, and use the tightly driven cushion to its position. The corresponding joint controls the rotation of the mixing drum.


請注意,關閉發動機,拆除液壓馬達的高壓油管,攪拌箱可以自由旋轉,控制攪拌箱的旋轉,將維護孔轉到下部,然后打開維護孔并清洗混凝土在氣缸中。這時,您必須注意性。卸載混凝土后,進料攪拌機返回到其原始狀態。
Please pay attention to safety, shut down the engine, remove the high pressure oil pipe of the hydraulic motor, the mixing tank can rotate freely, control the rotation of the mixing tank, turn the maintenance hole to the lower part, and then open the maintenance hole and clean the concrete in the cylinder. At this point, you must pay attention to security. After unloading the concrete, the feed mixer returns to its original state.
啟動自動上料小型攪拌車并將其操作手柄置于卸載位置,有缺陷的混凝土將被卸出。準備緊緊驅動軟管,關閉自動加載混合器,并卸下液壓馬達上的高壓燃油管接頭。
Start the small automatic loading mixer and put its operating handle in the unloading position, and the defective concrete will be discharged. Prepare to tighten the drive hose, close the autoloader mixer, and remove the high pressure fuel line fitting from the hydraulic motor.
修復自動上料小型攪拌車驅動的方法你學會了嗎?
Have you learned how to repair the drive of automatic feeding small mixer?

截屏,微信識別二維碼

RM新时代入口