We must understand the operation when using the automatic feeding mixer. There is a lot of difference between good operation and ordinary operation. How to operate is a good operation? Let's give you a detailed introduction.

科學生產一直是各個企業放在前位的大事，如何科學的操作自動上料攪拌車也是很重要的，今天，小編就帶大家一起來學習一下。

Scientific production has always been the top priority for all enterprises. How to operate the automatic feeding mixer scientifically is also very important. Today, Xiaobian will take you to learn it.

自動上料攪拌車操作 您真的懂嗎？

Do you really understand the operation of automatic feeding mixer?

自動上料攪拌車裝運攪拌好的混凝土?xí)r，攪拌筒轉速為2-10轉/分，在運送過程中，平整路面上攪拌筒轉速保證在2-3轉/分，行進在側傾斜度大于50的路面，或擺布晃動較大的路面時，應中止攪拌旋轉，待路況好轉后再攪拌旋轉。起動之前，應把攪拌筒操作手柄放在“中止”方位。起動發動機后，應使攪拌筒在低速下滾動10分鐘左右，使液壓油溫升到20℃以上后方可作業。

When the automatic loading mixer truck is used to transport the mixed concrete, the speed of the mixing drum shall be 2-10 rpm. During the transportation process, the rotation speed of the mixing drum shall be kept at 2-3 rpm on the smooth road surface. When the truck is traveling on the road with a side slope greater than 50 or swinging the road surface with large shaking, the mixing rotation shall be stopped and the mixing rotation shall be conducted after the road conditions are improved. Before starting, put the mixing drum operating handle in the "stop" position. After starting the engine, the mixing drum should be rolled at low speed for about 10 minutes, and the hydraulic oil temperature can be increased to above 20 ℃.

車內裝有混凝土?xí)r，在現場不得停留超越1小時，如超時應立即請求現場負責人給予及時處理。自動上料攪拌車運送混凝土塌落度不得低于8cm。從混凝土入罐到排出，氣溫高時不得超越2小時，陰雨氣候溫度低時，不得超越2.5小時。運送混凝土途中，攪拌筒不得長時間停轉，以防混凝土發生離析現象。司機應經常調查混凝土狀況，發現異常及時通報調度室，請求做出處理。

When the vehicle is filled with concrete, it is not allowed to stay at the site for more than 1 hour. If it exceeds the time limit, the person in charge of the site shall be asked to deal with it in time. The slump of concrete transported by automatic loading mixer shall not be less than 8cm. From the concrete entering the tank to discharging, it shall not exceed 2 hours when the temperature is high, and it shall not exceed 2.5 hours when the temperature is low in rainy climate. During the transportation of concrete, the mixing drum shall not be stopped for a long time to prevent concrete segregation. The driver shall often investigate the concrete condition, report to the control room in time if any abnormality is found, and request to deal with it.

自動上料攪拌車在露天停放時，裝料前應將攪拌筒回轉，將積水和雜物排出，以保證混凝土的質量。在運送混凝土?xí)r，要保證滑斗放置結實，防止因松動形成搖擺，在跋涉中打傷行人或影響其它車輛正常運轉。出料結束，應立即用隨車的軟管放水將進料口、出料斗及出料溜槽等部位沖洗干凈，再向攪拌筒內灌150-200L的清水，讓攪拌筒慢速滾動，以清洗內壁。

When the automatic loading mixer truck is parked in the open air, the mixing drum should be rotated before loading to discharge the water and debris, so as to ensure the quality of concrete. When transporting concrete, it is necessary to ensure that the sliding bucket is placed firmly to prevent swing due to looseness, which may injure pedestrians or affect the normal operation of other vehicles. At the end of discharging, immediately flush the inlet, discharge hopper and discharge chute with hose on the truck, and then fill 150-200l of clean water into the mixing drum to let the mixing drum roll slowly to clean the inner wall.