Some specific automatic feeding mixer drivers believe that the engine temperature is not low, so the engine thermostat will be automatically removed, and the coolant can only be removed from the night cycle.

由于無法調節冷卻強度，因此發動機通常在高溫條件下運行。這會導致磨損并增加燃油消耗。實際上，高溫對發動機有害。為了確保發動機的使用壽命，應將安裝自動上料攪拌車的用例限制在環境溫度范圍內。

Because the cooling intensity cannot be adjusted, the engine usually runs at high temperature. This causes wear and increases fuel consumption. In fact, high temperature is harmful to the engine. In order to ensure the service life of the engine, the use case of installing the automatic feeding mixer should be limited to the ambient temperature range.

橡皮筋很好。如果皮帶太松，不僅會拉伸并損壞皮帶，縮短皮帶的使用壽命，而且過大的壓力會自動加載并扭曲攪拌器的發電機軸和泵軸，從而損壞攪拌器。為了滿足技術要求，必須松開自動上料攪拌車的風扇皮帶。建議的組裝偏差為10-15毫米。

The rubber band is very good. If the belt is too loose, it will not only stretch and damage the belt, shorten the service life of the belt, but also the excessive pressure will automatically load and twist the generator shaft and pump shaft of the agitator, thus damaging the agitator. In order to meet the technical requirements, the fan belt of the automatic feeding mixer must be loosened. The recommended assembly deviation is 10-15mm.

許多駕駛員知道這輛車剛剛起步。同樣，如果發動機轉速過低，則由于打滑不良會損壞發動機。

Many drivers know that the car is just starting. Similarly, if the engine speed is too low, the engine will be damaged due to poor slip.

但是，大多數人都知道自動上料攪拌車中的油泵無法快速潤滑光滑表面上的潤滑劑，因為由于加熱速度較慢，它們將在短時間內處于閑置狀態。

However, most people know that the oil pump in the automatic feeding mixer can not quickly lubricate the lubricant on the smooth surface, because they will be idle for a short time due to the slow heating speed.

同時，由于高溫燃油霧化不足，燃燒的燃油進入曲軸箱，沖刷了氣缸壁上的油膜，并加速了零件的磨損。因此，在自潤滑發動機啟動后幾秒鐘的高溫條件下，有必要改善空轉加熱并提高發動機滑移率。

At the same time, due to the lack of high temperature fuel atomization, the burning fuel enters the crankcase, washes the oil film on the cylinder wall, and accelerates the wear of parts. Therefore, it is necessary to improve the idling heating and increase the slip ratio of the self-lubricating engine in the high temperature condition of a few seconds after starting.

自動上料攪拌車錯誤使用發動機的影響就是這些，你了解了嗎?如果還有不明白的地方，可以關注：http://kitchinit.com會有在線客服為您進行解答。

This is the impact of the wrong use of the engine of the automatic feeding mixer. Do you understand? If you still don't understand, you can pay attention to: http://kitchinit.com There will be online customer service to answer for you.