After each discharge, the tank truck with its own water gun shall be used to wash the tank mouth, blade, feeding mouth, tank body and corners, so as to prevent the concrete from accumulating more and more after melting. Otherwise, it is not easy to clear up. Every day after the delivery duty stops, add more than 1 cubic meter of purified water into the tank, and then the rotating tank stops cleaning. Qualified companies can also add stones in the tank, the effect will be better. Wash the tank car at any time during operation and clean it thoroughly after receiving.

攪拌一體車加水流程：控制氣壓，固禁接頭。罐體氣壓在出廠的時光已經設定好了，無需自己調節，假如出現特別情形須要自己調節，提議氣壓控制在3.5mpa閣下。

Mixing truck water flow: control the air pressure, solid forbidden joint. The air pressure of the tank has been set at the time of leaving the factory, so there is no need to adjust it by yourself. In case of special circumstances, you need to adjust it by yourself. It is suggested that the air pressure be controlled at 3.5Mpa.

由于原料差別，每一盤的混凝土品德都有些差別，裝好混凝土時，一定要檢查它的坍落度以及合易度，小心混凝土的提前熔化跟混凝土分層沉淀，以免運到現場后混凝土又不克不及投入運用，糟蹋人力物力時光。留心輸送的距離，可能造成混凝土品德改變，這個距離控制在直徑30范圍以內。

Due to the difference of raw materials, the concrete quality of each plate is different. When the concrete is installed, it is necessary to check its slump and workability. Be careful of the early melting of concrete and the layered precipitation of concrete, so as to avoid that the concrete can not be put into use after it is transported to the site, wasting manpower and material resources. Pay attention to the conveying distance, which may cause the change of concrete quality. The distance should be controlled within 30 km in diameter.

攪拌車出車之前計劃好道路以及車輛通行情形，只管增加車輛在路上的時光。碰到人為或許不可抵抗的要素招致無法卸料時，隨時檢查罐內情形，一旦發現有混凝土開端熔化，應立即卸料，以免造成全部罐體的報廢。

Plan the road and traffic situation before the mixer is out, just increase the time of vehicles on the road. In case of failure to discharge due to artificial or irresistible factors, check the condition in the tank at any time. Once it is found that the concrete begins to melt, discharge immediately to avoid scrapping of all tanks.