RM新时代入口

歡迎來到中科聚峰機械有限公司!

24小時服務熱線:

400-879-1999

點擊撥打服務熱線:400-879-1999
當前位置:首頁>新聞中心>常見問題自動上料攪拌車在冬季時如何維護?

自動上料攪拌車在冬季時如何維護?

來源:http://kitchinit.com/ 日期:2022-04-06 發布人:admin
概述:  冬季可以說是自上料攪拌車容易出現故障的季節,當然大家都知道,好的車況離不開我們?nèi)粘?duì)設備的細心維護。那么自動上料攪拌車在冬季時
  冬季可以說是自上料攪拌車容易出現故障的季節,當然大家都知道,好的車況離不開我們?nèi)粘?duì)設備的細心維護。那么自動上料攪拌車在冬季時如何維護呢?下面來看看吧。
  Winter can be said to be the season when the mixing truck is prone to failure. Of course, as we all know, good car condition cannot be separated from our daily careful maintenance of equipment. So how to maintain the automatic feeding mixer in winter? Take a look.
  在冷啟動時,請一定記得怠速空載運行5-10分鐘(嚴寒季節15-20分鐘),然后再往復低速空載運行3~5次,待系統充分預熱后再開始工作。自上料攪拌車啟動前務必檢查操縱裝置的操縱手柄是否置于停止位置,倘若發動機啟動時罐子處于高速旋轉狀態,瞬間產生的力會非常大,將極易造成減速機和泵馬達系統的損傷。
  In the cold start, please remember idle idle idle for 5-10 minutes (15-20 minutes in the cold season), and then reciprocating low speed no-load operation for 3~5 times, until the system fully warm up before starting to work. Be sure to check whether the handle of the control device is placed in the stop position before starting the feeding mixer. If the tank is in a state of high speed rotation when the engine starts, the instantaneous force will be very large, which will easily cause damage to the reducer and pump motor system.
  冬季雨雪天氣也會較為頻繁的出現,大家在行駛過程中,一定要注意,保持車距。隨時觀察路面結冰情況,提前減速,緩行通過。雨雪天氣行車時,更要保持好車距,切勿空擋滑行、急打方向、猛踩剎車。
  Winter rain and snow weather will be more frequent, we must pay attention to safety in the process of driving, keep the distance from the car. Observe the ice situation on the road at any time, slow down in advance, slowly through. Rain and snow weather driving, but also to maintain a good distance, do not slide in neutral, hit the direction, slam on the brakes.
  冬季施工時,由于環境溫度低的原因,自上料攪拌車的運轉處于不利的工況,液壓油低溫時粘度增大,使管路油流阻力和泵吸油阻力增大,在操作時應特別注意此種情況,以避免損壞設備。
  In winter construction, due to the low ambient temperature, the operation of the mixing truck is in an unfavorable condition. The viscosity of hydraulic oil increases at low temperature, which increases the resistance of pipeline oil flow and pump oil absorption. Special attention should be paid to this situation during operation to avoid damage to the equipment.
  另外,冬季用車應保持車身干凈整潔,因保溫罐衣的原因,應及時檢查減速機與罐體連接的縫隙處是否有等異物,如果有的話,需及時清理,避免勒壞油封造成漏油。
  In addition, winter car should keep the body clean and tidy, due to the reasons of thermal insulation tank clothes, should timely check whether there are foreign bodies at the gap between the reducer and the tank body, if there is, need to be cleaned in time, to avoid bad oil seal caused by oil leakage.
  冬季起步請一定要十分柔和緩慢,不要直接一腳油門就往前沖。這樣一方面是為了讓自動上料攪拌車發動機在未達到正常運轉溫度時負載盡量小,另一方面也是讓輪胎在沒熱起來,還處于較硬的狀態下的時候,有一個漸熱的過程。柔和的起步方式對自上料攪拌車發動機、輪胎及都有好處。啟動前也需要確??刂剖直幱谕V刮恢茫苊鈳лd啟動對液壓系統造成沖擊損傷。
  Winter start please be very soft and slow, do not directly a foot throttle forward. On the one hand, this is to make the load as small as possible when the engine of the loading agitator does not reach the normal operating temperature, on the other hand, it is also to make the tire not hot, but also in a hard state, there is a process of gradual heating. A gentle start is good for the engine, tires and safety of the self-loading agitator. Before starting, it is also necessary to ensure that the control handle is in the stop position to avoid impact damage to the hydraulic system caused by starting with load.
  當然會有人問到,冬季了,我家的自動上料攪拌車就不用工作了,限制在庫房中應該不需要維護了吧,其實這是一個誤區,當停用后再次啟用自上料攪拌車前,要對整體潤滑系統逐一檢查,必要時加油或換油。還有不懂的地方就來網站kitchinit.com咨詢吧。
  Of course, some people will ask, in winter, my automatic feeding mixer does not need to work, limited in the warehouse should not need to maintain it, in fact, this is a misunderstanding, when it is used again since the feeding mixer, to check the overall lubrication system one by one, if necessary, refueling or oil change. Still do not understand the place to the website kitchinit.com consultation.

截屏,微信識別二維碼

RM新时代入口