What should be paid attention to when adding fuel for automatic feeding mixer?

1.自動上料攪拌車在運行過程中不得維修和潤滑。

1. The automatic feeding mixer shall not be maintained and lubricated during operation.

2.定期向注油嘴注滿潤滑脂，每4小時向軸端密封圈注滿潤滑油，并每周排放一次污水。

2. Fill the grease nozzle with grease regularly, fill the shaft end sealing ring with lubricating oil every 4 hours, and discharge the sewage once a week.

3.使用自動上料攪拌車后，在每個潤滑點適當添加必要的潤滑油。

3. After using the automatic feeding mixer, add necessary lubricating oil at each lubricating point.

4.自動上料攪拌車齒輪箱的齒輪和軸承通過齒輪旋轉將油濺到箱內壁上，并流入軸承進行潤滑。變速箱的油位應保持在油尺的兩個刻度之間。如果油位過高或過低，每個零件的溫度將升高或潤滑不良，這將增加功率損耗并導致機器工作不良。

4. The gear and bearing of the gearbox of the automatic feeding mixer splash oil on the inner wall of the box through the rotation of the gear, and flows into the bearing for lubrication. The oil level of the gearbox should be maintained between the two scales of the dipstick. If the oil level is too high or too low, the temperature of each part will increase or the lubrication will be poor, which will increase the power loss and cause the machine to work poorly.

5.自動上料攪拌車選擇的潤滑油應具有一定的購置粘度和粘度溫度特性，凝固點低，抗氧化穩定性好，無機械雜質和濕氣，無腐蝕和磨損物。其質量指標應符合標準。

5. The lubricating oil selected for the automatic feeding mixer should have certain viscosity and viscosity temperature characteristics, low freezing point, good oxidation stability, no mechanical impurities, moisture, corrosion and wear. The quality index should meet the national standard.

自動上料攪拌車加油的注意問題就是這些，希望對你有幫助。

These are the problems that should be paid attention to when filling the automatic feeding mixer. I hope it will help you.