Mixer truck in use to a certain time, there will be some problems, so how to encounter these problems?

1、攪拌一體車自身的故障會影響混凝土攪拌機的工作效率。混凝土攪拌機的連桿、軸與襯板、可動顎板、偏心軸是主要的的磨損部件。生產過程中，應該經常觀察磨損情況，及時修理或更換磨損件，也要注意在潤滑點經常潤滑?；炷翑嚢铏C(jī)工作效率還有排料口大小的調節。

1. The failure of mixer truck itself will affect the working efficiency of concrete mixer. The connecting rod, shaft and lining plate, movable jaw plate and eccentric shaft of concrete mixer are the main wear parts. In the production process, we should often observe the wear situation, repair or replace the worn parts in time, and also pay attention to frequent lubrication at the lubrication point. The working efficiency of concrete mixer and the adjustment of discharge port size.

2、在生產中，需更據排礦粒度的要求調節排礦口大小。在保證產品粒度的要求下，可把排礦口放大提高生產效率，排礦口大小可以通過調節塊來調節。處理好生產率和破碎比之間的相互關系，可以使生產產量提高，大大提高了破碎生產線的生產經濟效益。

2. In production, it is necessary to adjust the size of ore outlet according to the requirement of ore size. Under the requirement of ensuring the product size, the ore outlet can be enlarged to improve the production efficiency, and the size of the ore outlet can be adjusted by adjusting the block. If the relationship between productivity and crushing ratio is well handled, the production output can be increased and the economic benefit of crushing production line can be greatly improved.

3、攪拌一體車偏心軸的轉數也會影響混凝土攪拌機的生產能力。攪拌機的偏心軸轉數越快，單位時間內的電能消耗也會增加。會導致攪拌腔中已被破碎機的礦石來不及排出，從而產生堵塞現象。使得生產能力大大降低，也增加了機器的負荷情況。

3. The rotation number of eccentric shaft of mixer truck will also affect the production capacity of concrete mixer. The faster the eccentric shaft rotation of the mixer, the higher the power consumption per unit time. It will cause the ore in the mixing chamber which has been crushed by the crusher to be discharged too late, resulting in the blockage phenomenon. So that the production capacity is greatly reduced, but also increased the load of the machine.