攪拌車在化工工業中運用比較多比較廣，很多的化工生產都或多或少地應用著攪拌操作，今天就簡單來看下自動攪拌車如何進行氣流攪拌？小編為您簡單講一講問題的相關內容吧。

Mixers are widely used in the chemical industry, and many chemical production uses mixing operations more or less. Today, let's simply look at how automatic mixers perform air flow mixing? Let's briefly talk about the relevant content of the problem.

氣流攪拌是利用氣體鼓泡通過液體層，對液體產生攪拌作用，或使氣泡群一密集狀態上升借所謂上升作用促進液體產生對流循環。與機械攪拌相比，僅氣泡的作用對液體進行的攪拌時比較弱的，對于幾千毫帕秒以上的高粘度液體是難于使用的。

Air flow stirring is to use the gas bubble to pass through the liquid layer and stir the liquid, or make the bubble group rise in a dense state to promote the convection circulation of the liquid by the so-called rising effect. Compared with mechanical agitation, the effect of bubbles on liquid agitation is relatively weak, and it is difficult to use high viscosity liquid above several thousand millipascals.

但氣流攪拌無運動部件，所以在處理腐蝕性液體，高溫高壓條件下的反應液體的攪拌時比較便利的。在工業生產中，攪拌操作時從化學工業開始的，圍繞食品、纖維、造紙、石油、水處理等，作為工藝過程的一部分而被廣泛應用。攪拌操作分為機械攪拌與氣流攪拌。

However, the air flow stirring has no moving parts, so it is convenient to handle corrosive liquids and the stirring of reaction liquids under high temperature and high pressure. In industrial production, the mixing operation starts from the chemical industry, and is widely used as a part of the technological process around food, fiber, paper making, oil, water treatment, etc. The mixing operation is divided into mechanical mixing and air flow mixing.

此外攪拌車作為運送混凝土的專用卡車，日常維護很重要，所以要保證攪拌車的使用壽命，須做好維護工作。如果對攪拌車的保養和維護不到位，將影響攪拌車的使用性能和壽命，比如：

In addition, as a special truck for transporting concrete, the daily maintenance of the mixer is very important, so the maintenance work must be done well to ensure the service life of the mixer. If the maintenance of the mixer truck is not in place, the service performance and life of the mixer truck will be affected, such as:

每天行車前檢查托輪與滾道的結合面潤滑油是否干澀，應及時補充，保持良好的潤滑效果，每次在車輛發動之前，檢查冷卻器和減速機的油位，保證油位指示在目視范圍內；檢查液壓油路的密封情況，保持液壓系統清潔和密封，以免塵粒和水分等污染系統液壓油，造成系統不能正常工作或損壞。

Before driving every day, check whether the lubricating oil on the joint surface between the supporting wheel and the raceway is dry, and replenish it in time to maintain a good lubrication effect. Before starting the vehicle each time, check the oil level of the cooler and reducer to ensure that the oil level indication is within the visual range; Check the sealing condition of the hydraulic oil circuit, keep the hydraulic system clean and sealed, so as to avoid contamination of the hydraulic oil of the system by dust particles and moisture, which may cause the system to fail to work normally or be damaged.

至少每月一次清理托輪和滾道上的污物；通過托輪上的油嘴，向托輪內注入潤滑油脂，保證傳動軸至少每月潤滑一次，液壓系統部件精度較高，尤其是攪拌車液壓泵，保養簡易，但要求很高，液壓油要定期更換，初次運行500小時，以后2000小時或至少每年更換一次，濾芯應該同時更換，加油或換油時，發動機須處于停止?fàn)顟B(tài)，否則將造成液壓系統損壞。

Clean the dirt on the supporting wheel and raceway at least once a month; Inject lubricating grease into the supporting wheel through the oil nozzle on the supporting wheel to ensure that the transmission shaft is lubricated at least once a month. The accuracy of the hydraulic system components is high, especially the hydraulic pump of the mixer truck. The maintenance is simple, but the requirements are high. The hydraulic oil should be replaced regularly, 500 hours after the initial operation, 2000 hours or at least once a year. The filter element should be replaced at the same time. The engine must be stopped when refueling or changing oil, Otherwise, the hydraulic system will be damaged.

自動攪拌車進行氣流攪拌的過程相關事項就為您講解到這里了，此外提醒您，要想您的攪拌車在使用期間少些問題多提高使用效率，就要平日中多檢查固定維護才行。更多事項就來關注我們網站http://kitchinit.com吧！

This is the end of the description of the process of air flow mixing with the automatic mixer. In addition, we remind you that in order to reduce the number of problems and improve the efficiency of your mixer during use, you need to check and maintain more regularly. Follow our website for more information http://kitchinit.com Come on!