The correct use of automatic feeding mixer is conducive to the smooth construction, and can improve the work efficiency of the project. If not properly used, it will damage the mechanical parts of the equipment and reduce its service life. The most important thing in use is to operate in strict accordance with the instructions. Generally in summer, if the temperature of the automatic feeding mixer is too high, it should stop immediately and continue to use after the temperature drops. Today, let's make a brief introduction to the correct use of radiator of automatic feeding mixer truck

1、備用的散熱器有效環境應保持通風、干燥。

1. The effective environment of standby radiator should be kept ventilated and dry.

2、建議使用軟硬水需軟化處理后使用，避免造成散熱器內部堵塞及水垢的產生。

2. It is suggested that soft and hard water should be used after softening treatment to avoid internal blockage and scale formation of radiator.

3、在冬季為防止結冰造成芯子破裂現象，如攪拌車長期停車或間接停車時，應將水箱蓋和放水開關，將水全部放出。

3. In winter, in order to prevent core breakage caused by freezing, such as long-term or indirect shutdown of the mixer, the water tank cover and water drain switch should be set to discharge all water.

4、水位計應每3個月清洗一次或視實際情況，各部件拆下用溫水加無腐蝕性洗滌劑清洗。

4. The water level gauge should be cleaned every 3 months or according to the actual situation, all parts should be removed and cleaned with warm water and non corrosive detergent.
 

5、散熱器內完全放水再注水時，要先將發動機缸體的放水開關扭開，有水流出時，再關上，從而避免產生水泡。

5. When the radiator is completely drained and then filled with water, the drain switch of the engine block should be turned on first, and then turned off when there is water flowing out, so as to avoid the generation of blisters.

6、在日常使用中應隨時檢查水位，要停機降溫后加水。加水時，將水箱蓋慢慢打開，作業人員身體應盡量遠離加水口，以防高壓蒸汽油加水口噴出造成燙傷。

6. In daily use, the water level should be checked at any time, and water should be added after shutdown and cooling. When adding water, the water tank cover shall be opened slowly, and the operator's body shall be kept away from the water inlet as far as possible, so as to prevent scalding caused by the spray of high-pressure steam gasoline.

7、散熱器不應與任何酸、堿或其它腐蝕性性質接觸。

7. The radiator shall not be in contact with any acid, alkali or other corrosive properties.

8、在使用防凍液，為了避免散熱器的腐蝕，請務必使用正規廠家生產且符合國家標準的長效防銹防凍液。

8. In the use of antifreeze, in order to avoid the corrosion of radiator, please be sure to use the long-term anti rust antifreeze produced by regular manufacturers and in line with national standards.

9、視實際情況用戶應在1～3個月間對散熱器進行完全清洗一次芯體。清洗時，用清水沿反進風向側沖洗。

9. According to the actual situation, the user should clean the radiator completely once every 1-3 months. When cleaning, wash with clean water along the side of the reverse wind direction.

10、在安裝散熱器過程中，請不要損壞散熱帶（片）和碰傷散熱器，以保證散熱能力和密封。

10. In the process of installing the radiator, please do not damage the strapdown (piece) and bump the radiator to ensure the heat dissipation capacity and sealing.

正確的操作方式，能夠有效提高自動上料攪拌車散熱器的使用效果，同時也能夠防止在使用過程中因操作不當而對設備造成的損耗。希望這些知識能夠幫助大家對設備進行合理的操作以及使用。

The correct operation mode can effectively improve the use effect of the radiator of the automatic feeding mixer, and at the same time, it can prevent the loss of the equipment caused by improper operation. I hope these knowledge can help you to operate and use the equipment reasonably.