應定期向與自動上料攪拌車相連的水箱中加水。

Water shall be added to the water tank connected to the automatic loading mixer on a regular basis.

，控制油箱壓力并經常擰緊各種配件

First of all, control the tank pressure and tighten various fittings frequently

無需調整儲罐中的壓力設置。如果在特殊情況下需要調節，建議將壓力控制在3.5Mpa左右。另外，在使用新車或日常使用時，請確保將其擰緊，以免連接器脫落。

There is no need to adjust the pressure setting in the tank. If adjustment is needed under special circumstances, it is recommended to control the pressure at about 3.5Mpa. In addition, when using a new car or daily use, please make sure to tighten it to prevent the connector from falling off.

二，油輪加水步驟

2、 Tanker filling procedure

每個油輪都有類似的供水。通常情況下，水箱要用水通風-閥門是關閉的。在不使用時將其居中。

Each tanker has a similar water supply. Normally, the tank is ventilated with water - the valve is closed. Center it when not in use.

三，冬季水箱中剩余的水

3、 Remaining water in the tank in winter

在冬季，特別是在北方，用戶需要從水箱和管道中排出水，將壓縮空氣吹入管道中，并從每根管道中排出殘留水。防止因凍結而凍結和破裂管道。

In winter, especially in the north, users need to drain water from water tanks and pipes, blow compressed air into pipes, and discharge residual water from each pipe. Prevent freezing and rupture of pipes due to freezing.

卸料過程中自動上料攪拌車的注意事項

Matters needing attention of automatic loading mixer in discharging process

1.以大速度操作混合箱1-2分鐘，然后降低其以徹底攪拌混凝土。

1. Operate the mixing tank at high speed for 1-2 minutes and then lower it to thoroughly mix the concrete.

2.排干物料后，將汽車盡可能停在平坦的表面上，并弄濕料斗斜槽以利于清潔。

2. After discharging the materials, park the car on a flat surface as far as possible, and wet the hopper chute to facilitate cleaning.

3.取出時查看材料，以免操作彈出桿。在轉動中間位置時停止油箱，以保護減速器，支撐輪等。

3. Check the material when taking it out to avoid operating the pop-up lever. Stop the oil tank when turning the middle position to protect the reducer, support wheel, etc.

4.清洗瓶子時，必須仔細清洗，將水反復倒轉兩次，將水箱中的水放進瓶子后放回站內，并向瓶子中加水。徹底清潔。

4. When cleaning the bottle, you must wash it carefully. Turn the water back twice. Put the water in the water tank into the bottle and put it back into the station, and add water to the bottle. Clean thoroughly.

為了在自動上料攪拌車設備運行期間確保設備的良好運行性能，有必要了解這些注意事項。避免由于對設備的了解不足而影響正常施工過程的操作錯誤。

In order to ensure the good operation performance of the equipment during the operation of the automatic feeding mixer, it is necessary to understand these precautions. Avoid the operation error that affects the normal construction process due to insufficient understanding of the equipment.

自動上料攪拌車儲水罐加水步驟和卸料的注意問題就是這樣了，希望對你有幫助。

Automatic feeding mixer tank water tank filling steps and unloading attention is like this, hope to help you.

自動上料攪拌車

Price of automatic feeding mixer