概述：由于車輛的長期行駛，水箱和冷凝器的前部會堆積一些塵土、柳絮等雜物，當堆積過多時，如不及時清理，會直接影響水箱和冷凝器的散熱功能。下
由于車輛的長期行駛，水箱和冷凝器的前部會堆積一些塵土、柳絮等雜物，當堆積過多時，如不及時清理，會直接影響水箱和冷凝器的散熱功能。下面來講講
自動攪拌車水箱水溫升高的危害以及預防措施。
Due to the long-term driving of the vehicle, some dust, catkins and other sundries will accumulate in the front of the water tank and condenser. If the accumulation is too much, if not cleaned in time, it will directly affect the heat dissipation function of the water tank and condenser. Now let's talk about the harm of the rising water temperature in the tank of the automatic mixer and the preventive measures.
自動攪拌車水箱水溫升高的危害。
Harm of rising water temperature in water tank of automatic mixer.
一、自動攪拌車水箱水溫度過高的話會加快活塞的磨損，造成溫度變化不勻稱,會影響到自動攪拌車的動力；
1、 If the water temperature in the tank of the automatic mixer is too high, it will accelerate the wear of the piston, cause uneven temperature changes, and affect the power of the automatic mixer;
二、容易造成車缸墊被熾穿；
2、 It is easy to cause burning through of the cylinder cushion;
三、造成活塞環拉缸等等，環境嚴重的大概會造成自動攪拌車動員機損害。
3、 If the environment is serious, it may cause damage to the automatic mixer.
如何防備自動攪拌車水箱溫度過高？
How to prevent the water tank temperature of automatic mixer from being too high?
1、經常查看水箱的水是否富?；蚴锹┧?/div>
1. Always check whether the water tank is rich or leaking;
2、查看電子扇是否正常動彈；
2. Check whether the electronic fan works normally;
3、查看溫度傳感器是否有損壞；
3. Check whether the temperature sensor is damaged;
4、檢查冷凝器管是否堵塞等等。
4. Check whether the condenser tube is blocked, etc.
因此，自動攪拌車司秘密經常做好車美容，以免車箱水溫升高，粉碎車的動力機能，給車造成無法修補的傷害。
Therefore, the automatic mixer truck company secretly often does a good job of car grooming to prevent the water temperature in the car body from rising and the power function of the crushing truck from causing irreparable damage to the car.
炎熱夏季經常會出現發動機溫度過高，甚開鍋的現象，嚴重時，活塞與缸筒之間，由于活塞熱量散不出去，膨脹過大，活塞與缸筒之間的間隙減少甚消失，產生硬性拉動，造成拉缸，這點是十分重要的。更多相關事項了解就來咨詢我們
http://kitchinit.com！
In hot summer, the engine temperature is often too high, or even the boiler is boiling. In serious cases, the gap between the piston and the cylinder barrel is reduced or even disappeared due to the excessive expansion of the piston due to the heat that cannot be dissipated. This is very important. Please contact us for more information http://kitchinit.com ！
點擊撥打服務熱線：400-879-1999
