RM新时代入口

歡迎來到中科聚峰機械有限公司!

24小時服務熱線:

400-879-1999

點擊撥打服務熱線:400-879-1999
當前位置:首頁>新聞中心>公司動態如何科學操作料攪拌車?

如何科學操作料攪拌車?

來源:http://kitchinit.com/ 日期:2021-04-01 發布人:admin
概述:科學生產一直是各個企業放在前位的大事,如何科學的操作自動上料攪拌車也是很重要的,今天,小編就帶大家一起來學習一下。
科學生產一直是各個企業放在前位的大事,如何科學的操作自動上料攪拌車也是很重要的,今天,小編就帶大家一起來學習一下。
Scientific production has always been the top priority of various enterprises. How to operate the automatic feeding mixer scientifically is also very important. Today, Xiaobian will take you to learn.
自動上料攪拌車裝運攪拌好的混凝土?xí)r,攪拌筒轉速為2-10轉/分,在運送過程中,平整路面上攪拌筒轉速保證在2-3轉/分,行進在側傾斜度大于50的路面,或擺布晃動較大的路面時,應中止攪拌旋轉,待路況好轉后再攪拌旋轉。起動之前,應把攪拌筒操作手柄放在“中止”方位。起動發動機后,應使攪拌筒在低速下滾動10分鐘左右,使液壓油溫升到20℃以上后方可作業。
When the automatic feeding mixer transports the mixed concrete, the rotation speed of the mixing drum is 2-10 rpm. During the transportation, the rotation speed of the mixing drum on the smooth road surface is guaranteed to be 2-3 rpm. When moving on the road surface with the side slope greater than 50 or the road surface with large swing, the mixing rotation should be stopped, and the mixing rotation should be carried out after the road condition is improved. Before starting, put the operating handle of the mixing drum in the "stop" position. After starting the engine, the mixing drum should be rolled at a low speed for about 10 minutes to make the hydraulic oil temperature rise to more than 20 ℃.
車內裝有混凝土?xí)r,在現場不得停留超越1小時,如超時應立即請求現場負責人給予及時處理。自動上料攪拌車運送混凝土塌落度不得低于8cm。從混凝土入罐到排出,氣溫高時不得超越2小時,陰雨氣候溫度低時,不得超越2.5小時。運送混凝土途中,攪拌筒不得長時間停轉,以防混凝土發生離析現象。司機應經常調查混凝土狀況,發現異常及時通報調度室,請求做出處理。
When the vehicle is filled with concrete, it shall not stay at the site for more than 1 hour. If it exceeds the time limit, it shall immediately request the person in charge of the site for timely treatment. The slump of concrete transported by automatic feeding mixer shall not be less than 8cm. From the time of concrete entering the tank to discharging, it shall not exceed 2 hours when the temperature is high, and it shall not exceed 2.5 hours when the temperature is low in rainy weather. During the transportation of concrete, the mixing drum shall not stop for a long time to prevent concrete segregation. The driver shall regularly investigate the concrete condition, report the abnormal condition to the dispatching room in time, and request for handling.
自動上料攪拌車在露天停放時,裝料前應將攪拌筒回轉,將積水和雜物排出,以保證混凝土的質量。在運送混凝土?xí)r,要保證滑斗放置結實,防止因松動形成搖擺,在跋涉中打傷行人或影響其它車輛正常運轉。出料結束,應立即用隨車的軟管放水將進料口、出料斗及出料溜槽等部位沖洗干凈,再向攪拌筒內灌150-200L的清水,讓攪拌筒慢速滾動,以清洗內壁。
When the automatic feeding mixer is parked in the open air, the mixing drum should be rotated before loading to discharge the water and sundries, so as to ensure the quality of concrete. It is necessary to prevent the vehicle from sliding or rocking during transportation, so as to ensure the stability of the vehicle. At the end of discharging, immediately flush the feeding port, discharging hopper and discharging chute with the hose on the truck, and then pour 150-200l clean water into the mixing drum to let the mixing drum roll slowly to clean the inner wall.

截屏,微信識別二維碼

RM新时代入口