RM新时代入口

歡迎來到中科聚峰機械有限公司!

24小時服務熱線:

400-879-1999

點擊撥打服務熱線:400-879-1999
當前位置:首頁>新聞中心>行業新聞攪拌一體車為什么配備供水系統?

攪拌一體車為什么配備供水系統?

來源:http://kitchinit.com/ 日期:2021-02-10 發布人:admin
概述:攪拌一體車在停止工作或中斷工作一段時間的情況下,會出現混凝土滯留的問題。如果混凝土在攪拌罐呢你停留的時間過長,混凝土就會出現凝結現
攪拌一體車在停止工作或中斷工作一段時間的情況下,會出現混凝土滯留的問題。如果混凝土在攪拌罐呢你停留的時間過長,混凝土就會出現凝結現象,甚會與附著物體凝結為一體,致使攪拌筒等設備報廢。
When the mixer stops working or stops working for a period of time, there will be the problem of concrete retention. If the concrete stays in the mixing tank for a long time, the concrete will coagulate, or even coagulate with the attached objects, resulting in the scrapping of the mixing drum and other equipment.
同時,由于工作性質或環境的限制,混凝土不可避免的將對整車的各個系統有一定的污染。在一次運輸過程完畢后,如果不進行一定的清洗,凝結的混凝土將會給輸送車及機器的漆面帶來極大的損壞,特別是混凝土中有腐蝕型添加劑的時候,其破壞性會更大。
At the same time, due to the limitations of working nature or environment, concrete will inevitably pollute each system of the vehicle. At the end of a transportation process, if not cleaned, the solidified concrete will bring great damage to the paint surface of the truck and machine, especially when there are corrosive additives in the concrete.
為了防止上述問題發生,也是為了在一段運用過程完畢后能夠留下一段運送工作做好準備,攪拌運輸車都配備了供水系統。
In order to prevent the above problems, but also in order to be able to leave a section of transport work after the completion of a period of operation to prepare, the mixer truck is equipped with water supply system.
攪拌車的常用供水系統只是用于對料斗和卸料槽等部位進行沖洗,不用于對于混凝土進行供水或補水。
The common water supply system of mixer truck is only used to wash the hopper and discharge tank, not to supply water or make up water for concrete.
用直流電機水泵將存水箱中的水抽出,通過水管和噴嘴對攪拌車進行沖洗。它的水箱存水量不大,一般在200-250L之間。如果針對混凝土攪拌的供水系統,就需要大型水箱,存水量一般不低于600L。
The water in the storage tank is pumped out by DC motor water pump, and the mixer is washed by water pipe and nozzle. Its water storage tank is small, generally between 200-250l. If the water supply system for concrete mixing needs a large water tank, the storage capacity is generally not less than 600L.
近年來,對于一些中小容量的攪拌運輸車,為簡化供水系統的結構、節省動力和減輕上裝重量,常常省去水泵,采用氣壓噴水系統,他是汽車底盤儲氣筒后再加裝一個減壓副儲氣筒,氣壓力通過管路進入村水上方,水即在壓力作用下噴出。
In recent years, in order to simplify the structure of the water supply system, save power and reduce the loading weight of some small and medium capacity mixer trucks, the water pump is often omitted and the air pressure water spraying system is adopted. After the air reservoir of the car chassis, a decompression auxiliary air reservoir is added. The air pressure enters the village water through the pipeline, and the water is ejected under the pressure.
氣壓供水系統由壓力箱、球閥、順序閥、減壓閥、閥等組成。壓縮空氣。然后進滿水溢流口,見有水溢出,即關閉閘閥。使用壓力水箱里的水時,先打開球閥,壓縮空氣經順序閥、減壓閥、閥,與水箱接通,水即可沿管路和閥門泵送到?jīng)_洗管和攪拌筒。車輛行駛,關閉球閥,確保剎車氣源。
The pneumatic water supply system consists of pressure box, ball valve, sequence valve, pressure reducing valve and safety valve. Compressed air. Then fill the overflow port with water and close the gate valve when water overflows. When using the water in the pressure water tank, open the ball valve first, connect the compressed air with the water tank through the sequence valve, pressure reducing valve and safety valve, and the water can be pumped to the flushing pipe and mixing drum along the pipeline and valve. When the vehicle is running, close the ball valve to ensure the brake air supply.
以上就是小編總結的關于混凝土攪拌車的供水系統介紹,你學到了嗎?如有更多的疑問,可關注公司網站:http://kitchinit.com,后續會呈現更多的精彩內容,感謝大家長期以來的支持!
The above is the introduction of water supply system of concrete mixer summarized by Xiaobian. Have you learned it? If you have more questions, please pay attention to the company website: http://kitchinit.com More wonderful content will be presented in the future. Thank you for your long-term support!

截屏,微信識別二維碼

RM新时代入口