Everyone should be familiar with the automatic loading mixer. Today, we will discuss the maintenance function of the automatic feeding mixer driver.

驅動器用于驅動混凝土罐的旋轉。它由輸出單元，驅動軸，液壓泵，液壓馬達，控制閥，液壓油箱和冷卻單元組成。如果某個組件由于故障而失效，則混凝土罐將不會旋轉，車輛中的混凝土將被丟棄，整個罐中的混凝土將在罐中凝結，并且自動上料攪拌車將損壞小的混凝土。因此，驅動器是否可靠是在使用過程中必須理解的問題。為確保驅動器處于良好狀態，您必須執行以下維護任務：

The drive is used to drive the rotation of the concrete tank. It is composed of output unit, drive shaft, hydraulic pump, hydraulic motor, control valve, hydraulic oil tank and cooling unit. If a component fails due to failure, the concrete tank will not rotate, the concrete in the vehicle will be discarded, the concrete in the whole tank will set in the tank, and the small concrete will be damaged by the automatic feeding mixer. Therefore, whether the drive is reliable or not is a problem that must be understood in the use process. To ensure that the drive is in good condition, you must perform the following maintenance tasks:

1.通用旋轉零件是有缺陷的零件。逐漸注滿潤滑脂，并始終檢查是否磨損，修理和更換。如果不成功，團隊將需要另一個萬向軸組件來在數分鐘內恢復。

1. General rotating parts are defective parts. Gradually fill with grease and always check for wear, repair and replacement. If not, the team will need another Cardan assembly to recover in a few minutes.

2.檢查液壓油是否臟了。自動上料攪拌車的工作環境非常惡劣，必須防止臟的水泥砂進入液壓系統。應根據手冊的要求定期更換液壓油。如果液壓油中含有水或沙子，請立即關閉液壓系統并更換液壓油。

2. Check whether the hydraulic oil is dirty. The working environment of the automatic loading mixer is very bad, so the dirty cement sand must be prevented from entering the hydraulic system. The hydraulic oil should be changed regularly according to the manual. If the hydraulic oil contains water or sand, shut down the hydraulic system immediately and replace the hydraulic oil.

3.檢查液壓油冷卻器是否正常工作。定期清潔液壓油散熱器，以使水泥不會阻塞散熱器。檢查散熱器風扇是否正常運行，并且液壓油溫度已超過。只要保證液壓部件能夠清潔液壓油，故障通常很小，但制造商的使用壽命會有所不同。

3. Check whether the hydraulic oil cooler works normally. Clean the hydraulic oil radiator regularly so that the cement does not block the radiator. Check whether the radiator fan operates normally and the hydraulic oil temperature has exceeded. Usually, the hydraulic oil manufacturer can guarantee the service life of hydraulic components as long as they are clean.

污泥對自動上料攪拌車的影響。

The influence of sludge on the automatic loading mixer.

自動上料攪拌車通常用于建筑行業，但使用時無法避免產生淤泥。

Automatic loading mixer is usually used in construction industry, but it can't avoid sludge.

1.減少發動機廢氣排放，并縮短火花塞，氧氣傳感器和三元催化器的壽命。

1. Reduce engine exhaust emissions and shorten the service life of spark plug, oxygen sensor and three-way catalytic converter.

2.發動機輸出功率降低，加速不平穩，燃油消耗增加。

2. The engine output power is reduced, the acceleration is not stable, and the fuel consumption is increased.

3.很難冷啟動自動上料攪拌車。冷軌空轉速度不能達到指定速度。在嚴重的情況下，冷車的冷速會關閉，而熱車后的怠速會降低。

3. It is difficult to cold start the automatic feeding mixer. The idle speed of cold rail cannot reach the specified speed. In severe cases, the cold speed of the cold car will be turned off, and the idle speed will be reduced after the hot car.

4.積碳會堵塞發動機的活塞環，影響活塞環的密封性能，增加自動上料攪拌車的機油消耗，使發動機燃燒機油并縮短發動機的壽命。

4. Carbon deposition will block the piston ring of the engine, affect the sealing performance of the piston ring, increase the oil consumption of the automatic feeding mixer, make the engine burn oil and shorten the service life of the engine.

以上是污泥對自動上料攪拌車的影響，因此在使用自動上料攪拌車后，必須對其進行清潔以防止污泥積聚。

The above is the impact of sludge on the automatic feeding mixer. Therefore, after using the automatic feeding mixer, it must be cleaned to prevent sludge accumulation.

自動上料攪拌車在維護驅動和油泥帶來的影響了解就是這樣了，希望對你有幫助。

Automatic feeding mixer in the maintenance drive and sludge impact understanding is like this, hope to help you.