The automatic loading mixer not only has the function of transporting soil, but also has the function of mixing soil. Because of the characteristics of soil, it will dry after a short time, so it can be mixed all the time. The mixing of soil requires a mixing shaft. How to solve the problem if the mixing shaft stops rotating during operation?

自動上料攪拌車

Automatic feeding mixer

一、自動上料攪拌車攪拌軸停止轉動的原因

1、 The reason why the mixing shaft of automatic feeding mixer stops rotating

1、電機傳動皮帶有沒有出現松動的情況？

1. Is the motor drive belt loose?

自動上料攪拌車電機傳動皮帶過松也能導致商品混凝土拌合機攪拌軸轉動緩慢或者停止轉動，電機傳動皮帶過松，導致傳遞的動力不足。

The motor drive belt of the automatic feeding mixer truck is too loose, which can cause the mixing shaft of the commercial concrete mixer to rotate slowly or stop rotating, and the motor drive belt is too loose, resulting in insufficient power transmission.

2、攪拌葉片或側葉片與筒體內壁間有沒有大的異物？

2. Is there any large foreign matter between the mixing blade or side blade and the inner wall of the cylinder?

出現這種情況也會使攪拌車攪拌軸停止轉動或轉動緩慢。攪拌葉片或側葉片與罐內壁間有較大的異物也會導致攪拌軸停轉，之所以能卡存異物，由于攪拌葉片或側葉片與罐內壁間隙過大造成的。尤其是石子。

In this case, the mixing shaft of the mixer truck will stop or rotate slowly. The large foreign matter between the mixing blade or side blade and the inner wall of the tank will also cause the mixing shaft to stop rotating. The reason why the foreign matter can be stuck is due to the large gap between the mixing blade or side blade and the inner wall of the tank. Especially stones.

二、自動上料攪拌車攪拌軸停止轉動該如何解決

2、 How to solve the problem that the mixing shaft of automatic feeding mixer stops rotating

1、自動上料攪拌車電機傳動皮帶過松的情況，只需停機后調整混凝土攪拌機電機傳動皮帶的張緊度即可。

1, automatic feeding mixer motor transmission belt loose condition, just stop after adjusting the concrete mixer motor drive belt tension degree can be.

2、側葉片與關內壁卡滯物料時，在攪拌軸停轉前往往會有尖銳刺耳的摩擦聲，出現這種情況立即停機檢查，人工排除異物，重新調整混凝土自動上料攪拌車攪拌葉片或側葉片與罐內壁間的間隙，有必要時可以用水先清洗下。

2. When materials are stuck between the side blade and the inner wall of the closing wall, there is often a sharp and harsh friction sound before the mixing shaft stops running. In this case, stop the machine immediately for inspection, remove foreign matters manually, and readjust the gap between the mixing blade or the side blade and the inner wall of the tank of the automatic concrete feeding mixer truck. If necessary, clean it with water first.

自動上料攪拌車的消耗很大，既要運輸又要攪拌泥土的作用，那么尤其是它的攪拌軸一定要及時檢查，正常情況下隨著車的運行攪拌軸不斷轉動。如果停止轉動，及時查找原因并解決。

Under the condition of mixing truck, it is necessary to check the normal operation of the mixer shaft. If it stops rotating, find out the cause and solve it in time.

以上就是有關自動上料攪拌車的相關問題了，希望對您有所幫助。

The above is about the automatic feeding mixer related issues, I hope to help you.